M45 V8-4.5L (VK45DE) (2006)
^
A malfunction message will be displayed on the CONSULT-II screen,
6
A copy of the screen will automatically be printed.
CAUTION:
If any of the messages shown are displayed/printed reprogramming must be performed again.*
1.
Turn the ignition OFF and CONSULT-II OFF.
2.
* Make sure CONSULT-II and the ignition are OFF for more than 10 seconds before continuing.*
3.
Perform the complete procedure in this TSB again; starting at Part 1. Perform all steps in all sections exactly as instructed.
The exact cause of the error messages is not known; therefore you must perform the entire procedure again. This includes the following:
^
Downloading the special Y50 ICC reprogramming data from ASIST onto the 8MB (orange) reprogramming card.
^
* Make sure all DTCs are repaired and erased from all CONSULT-II compatible systems.
^
Make sure all connections of the ICC reprogramming cable CONSULT-II DLC cables and CONSULT-II Converter cables are tight.
^
Make sure the battery charger is connected and charging at the correct charge rate.