M45 V8-4.5L (VK45DE) (2006)
/Page-638009.png)
^
Apply new engine oil to both oil seal lip and dust seal lip.
^
Install it so that each seal lip is oriented as shown in the figure.
CAUTION:
^
Be careful not to scratch or make burrs on circumference of oil seal.
^
Using front oil seal drift (commercial service tool), press fit until the height of front oil seal is level with the mounting surface.
Front oil seal drift
Outer diameter: 56 mm (2.20 inch)
Inner diameter: 49 mm (1.93 inch)
^
Make sure the garter spring is in position and seal lips not inverted.
9. Install chain tensioner cover to front cover.
^
Apply a continuous bead of liquid gasket with tube presser [SST: WS39930000 ( - )] to front cover as shown in the figure.
^
Use Genuine RTV Silicone Sealant or equivalent.
10. Install front cover as follows:
a. Install new O-rings onto cylinder heads (right and left bank) and cylinder block.
