M45 V8-4.5L (VK45DE) (2006)
5. Touch "WORK SUPPORT".
6. Touch "LASER BEAM ADJUST".
7. Touch "START".
CAUTION: If the adjustment screen does not appear on the CONSULT-II screen in 10 seconds. After touching "LASER BEAM ADJUST"
screen, the following causes may be considered:
-
Target is not set accurately.
-
There is not enough space beside the target.
-
The range of laser beam aiming exceeds for improper installation position.
-
Deformation of vehicle body.
-
Deformation of unit.
-
Deformation of bracket.
-
The area is not suitable for the adjustment work.
-
ICC sensor integrated unit is not clean.