M45 V8-4.5L (VK45DE) (2006)
c.
Select [CONFIRM I-KEY ID].
d.
Push any one of the remote control buttons on an Intelligent Key (see Figure 1). The MEMORY location number for that key will be
indicated on the CONSULT-II screen.
e.
Repeat step d for each registered Intelligent Key. Each registered key will have its own MEMORY location number.
NOTE:
If a MEMORY location number is indicated when pushing a button on an Intelligent Key then it is registered. If "NOT REGIST" is displayed
on the CONSULT-II screen that key is not registered.
10.
Select [END] then [BACK] to return to the SELECT SYSTEM screen.
11.
Turn the ignition switch OFF and remove the Intelligent Key from key slot.
12.
Turn the CONSULT-II unit OFF and disconnect it from the vehicle.
SERVICE PROCEDURE B: NATS C/U Initialization, Add/Register Intelligent Key ID for IVIS [NATS], and Steering Lock Unit ID Registration
Before starting this procedure, please read the following:
NATS C/U Initialization
^
For CONSULT-II: Use the NATS (purple) Program Card version AEN04A-1 or later.
^
When the Intelligent Key is registered two registration procedures (C/U INITIALIZATION and Intelligent Key ID registration) should be
performed.
C/U INITIALIZATION: This procedure registers the ID for IVIS [NATS] stored to the transponder (integrated into the Intelligent Key) to the
BCM.
Intelligent Key ID Registration: This procedure registers the ID for Intelligent Key System to the Intelligent Key unit.
^
Always check the function of all Intelligent Keys after registration.