M45 V8-4.5L (VK45DE) (2006)
c. Tighten oil pan mounting bolts to the specified torque in numerical order shown in the figure after temporarily tightening them. Tighten oil pan
mounting bolts to the specified torque. Refer to "COMPONENTS".
CAUTION: Do not reuse oil pan mounting bolts.
16. Install drain plug to oil pan. Tighten drain plug to the specified torque. Refer to "COMPONENTS".
CAUTION: Do not reuse drain plug gasket.
17. Pull up A/T assembly harness connector.
CAUTION: Be careful not to damage connector.
18. Install snap ring to A/T assembly harness connector.
19. Connect A/T assembly harness connector.
20. Connect heated oxygen sensor 2 harness connector.
21. Pour ATF into A/T assembly.
22. Connect the battery cable to the negative terminal.