M45x AWD V8-4.5L (VK45DE) (2008)
/Page-1387004.png)
switch (during the indicator LED is illuminated).
-
To enter driver seat positions in blank memory, indicator LED will be illuminated for 5 seconds.
-
To modify driver seat positions, indicator LED will be turned OFF for 0.5 second then illuminated for 5 seconds.
6.
-
If you need setting of INTELLIGENT KEY INTERLOCK OPERATION, continue this procedure.
-
If you don't need setting of INTELLIGENT KEY INTERLOCK OPERATION, the procedure is finished. Conform the operations of each part
with the MEMORY OPERATION.
7. Press intelligent key unlock button within 5 seconds after pressing memory switch. (While memory switch LED is illuminated.)
8. Conform the operations of each part with MEMORY OPERATION and INTELLIGENT KEY INTERLOCK OPERATION.
NOTE: Driving position is erased from the memory when battery cable is disconnected.
EXITING OPERATION
When exiting, when the condition is satisfied, the seat is moved backward 40 mm (1.57 in) from normal sitting position and the steering is moved to the
most upper position and front position.
The seat slide amount and the steering operation at entry/exit operation can be changed by set switch, CONSULT- III and display (located in the
instrument panel). Refer to "SETTING CHANGE FUNCTION".
Operation Condition
-
Ignition switch: OFF / Driver side door switch: ON (OPEN)
If the following conditions are not satisfied, exiting operation is not performed.
-
Ignition switch is in OFF position.
-
A/T selector lever position is in P position.
-
Vehicle speed is less than 7 km/h. (4 MPH).
-
Driver side power seat switch and ADP steering switch are not operated.
-
Seat memory switch and set switch is not operated.
-
Door mirror control switch is not operated at change over switch is in LH or RH position.
-
Output malfunction is not detected.
-
Detention switch malfunction is not detected. [Detention switch malfunction is sensed when detention switch remains OFF and vehicle speed is
higher than 7 km/h. (4 MPH).]
-
CAN communications are normal.
-
Initialization has been done. Refer to "INITIALIZATION PROCEDURE".
ENTRY OPERATION
When the seat is in the exiting position when either condition (1 or 2) is satisfied, the seat returns from exiting position to the previous driving position.
Operation Condition
1. Ignition switch: ON
2. Ignition switch: ACC / Driver side door switch: OFF (CLOSE)
If the following conditions are not satisfied, entry operation is not performed.
-
Ignition switch is in OFF position.
-
A/T selector lever position is in P position.
-
Vehicle speed is less than 7 km/h (4 MPH).
-
Driver side power seat switch, ADP steering switch and door mirror control switch are not operated.
-
Seat memory switch and set switch is not operated.
-
Output malfunction is not detected.
-
Detention switch malfunction is not detected.
[Detention switch malfunction is sensed when detention switch remains OFF and vehicle speed is higher than 7 km/h (4 MPH).]
-
CAN communications are normal.
-
Exiting positions have not been changed during and after exiting operation.
INTELLIGENT KEY INTERLOCK OPERATION
When pressing unlock button on Intelligent Key or request switch, the system performs memory operation, exiting operation and entry operation.
Operation procedure
1. Press unlock button on Intelligent Key or request switch.
2. The system performs MEMORY OPERATION, and then performs EXITING OPERATION continually.
NOTE: If the seat position is in memorized position before push unlock button, MEMORY OPERATION dose not perform.
