M45x AWD V8-4.5L (VK45DE) (2008)
/Page-446002.png)
EM-200 Component (Part 2)
REMOVAL
1. Remove engine assembly from vehicle.
2. Remove the following components and related parts:
^
Drive belt auto tensioner and idler pulley
^
Thermostat housing and hoses
^
Ignition coil
^
Rocker cover
3. If necessary, remove intake valve timing control position sensor (right bank and left bank) and camshaft position sensor (PHASE) from intake
valve timing control cover and front cover.
CAUTION:
^
Handle carefully to avoid dropping and shocks.
^
Never disassemble.
4. If necessary, remove intake valve timing control solenoid valve from intake valve timing control cover.
CAUTION:
^
Handle components and parts carefully to avoid dropping and shocks.
^
Never disassemble.
^
Never allow metal powder to adhere to magnetic part at sensor tip.
^
Never place sensors in a location where they are exposed to magnetism.
5. Remove intake valve timing control cover as follows:
