M45x AWD V8-4.5L (VK45DE) (2008)
/Page-653004.png)
9. Remove fuel injector from fuel tube as follows:
a. Open and remove clip.
b. Remove fuel injector from fuel tube by pulling straight.
CAUTION:
^
Be careful with remaining fuel that may go out from fuel tube.
^
Be careful not to damage injector nozzles during removal.
^
Never bump or drop fuel injector.
^
Never disassemble fuel injector.
10. Remove fuel feed damper.
INSTALLATION
1. Install fuel feed damper.
^
When handling new O-rings, be careful of the following caution.
CAUTION:
^
Handle O-ring with bare hands. Never wear gloves.
^
Lubricate O-ring with new engine oil.
^
Never clean O-ring with solvent.
^
Check that O-ring and its mating part are free of foreign material.
^
When installing O-ring, be careful not to scratch it with tool or fingernails. Also be careful not to twist or stretch O-ring. If O-ring
was stretched while it was being attached, never insert it quickly into fuel tube.
^
Insert new O-ring straight into fuel tube. Never decenter or twist it.
^
Insert fuel feed damper straight into fuel tube (RH).
^
Tighten mounting bolts evenly in turn.
^
After tightening mounting bolts, check that there is no gap between flange and fuel tube (RH).
2. Install new O-rings to fuel injector paying attention to the following caution.
CAUTION:
^
Upper and lower O-ring are different. Be careful not to confuse them.
Fuel tube side: Black
Nozzle side: Green
^
Handle O-ring with bare hands. Never wear gloves.
^
Lubricate O-ring with new engine oil.
^
Never clean O-ring with solvent.
^
Check that O-ring and its mating part are free of foreign material.
^
When installing O-ring, be careful not to scratch it with tool or fingernails. Also be careful not to twist or stretch O-ring. If O-ring
was stretched while it was being attached, never insert it quickly into fuel tube.
^
Insert O-ring straight into fuel injector. Never decenter or twist it.
