Q45 V8-4.5L (VK45DE) (2002)
Tape Player: All Technical Service Bulletins
Cassette Player/Console - Trim Gaps
Classification:
BT01-020
Reference:
ITB01-036
Date:
June 12, 2001
IMPROPER GAP BETWEEN CASSETTE PLAYER FINISHER AND CENTER CONSOLE
APPLIED VEHICLE:
2002 Q45 (F50)
SERVICE INFORMATION
If the gap between the cassette player finisher and center console is improper (i.e., too big) the cause may be an improperly adjusted cassette player. Use
the Service Procedure to adjust the cassette player to obtain the proper gap.
SERVICE PROCEDURE
1.
Remove the cassette player finisher by carefully pulling out on the finisher until the clips are released (see Figure 1).
NOTE:
Use caution when pulling on the cassette finisher not to break the clips. However, if one of the clips on the finisher accidentally breaks, you will have
to order a new finisher. Refer to the Parts Information table for the replacement finisher part number.
2.
Remove the automatic transmission (A/T) finisher as follows: