Q45 V8-4.5L (VK45DE) (2002)
Install the new throttle pedal assembly (see Figure 1) using the procedures listed below.
NOTE:
The accelerator wire must be adjusted whenever any component of the accelerator pedal system is changed.
Accelerator Pedal Removal
1.
Remove the engine cover.
2.
Loosen the lock nut and remove the accelerator wire from the throttle drum (see Figure 2 shown).
3.
Remove the accelerator wire from the accelerator pedal (see Figure 2).
4.
Remove the accelerator pedal bracket nuts, then remove the accelerator pedal and bracket assembly (see Figure 2).
Accelerator Pedal Installation
Install in reverse order of the removal procedures, paying close attention to the following cautions:
CAUTION:
^
Do not cut, twist or kink the accelerator wire.