Q45 V8-4.5L (VK45DE) (2002)
Air Bag Control Module: Service and Repair
REMOVAL
CAUTION:
-
Before servicing SRS, turn the ignition switch off, disconnect the battery ground cable and wait at least 3 minutes.
1. Disconnect each harness connector for the air bag module and seat belt pre-tensioner.
2. Remove center console. Refer to "INSTRUMENT PANEL ASSEMBLY" .
3. Disconnect diagnosis sensor unit connector.
4. To remove special bolts, using TAMPER RESISTANT TORX (T50) from diagnosis sensor unit.
CAUTION:
-
Do not use old bolts. Replace with new ones.
-
Check diagnosis sensor unit brackets to ensure it is free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace it
with new one.
-
Replace diagnosis sensor unit if it has been dropped or sustained an impact.
INSTALLATION
To install, reverse the removal procedure sequence.
CAUTION:
-
Check the diagnosis sensor unit for proper installation.
-
After replacement of diagnosis sensor unit, perform self-diagnosis to check that no malfunction is detected. Refer to "SRS Operation Check" .
ECU DISCRIMINATED NO.
After replacing the diagnosis sensor unit, confirm that the diagnosis sensor unit identification No. is F317.