infiniti Workshop Repair Guides

Infiniti Workshop Service and Repair Manuals

Removal And Installation|Page 14001 > < Removal And Installation|Page 13999
Page 2
background image

-

Never apply water to the deployed air bag module and seat belt pre-tensioner.

-

Wash your hands clean after finishing work.

-

Place the vehicle outdoors with an open space of at least 6 m (20 ft) on all sides when deploying air bag module and seat belt pre-tensioner while
mounted in vehicle.

-

Use a voltmeter to make sure the vehicle battery is fully charged.

-

Do not dispose of the air bag module and seat belt pre-tensioner un-deployed.

DEPLOYMENT PROCEDURES FOR SEAT BELT PRE-TENSIONER (OUTSIDE OF VEHICLE)

1. Firmly grip pre-tensioner in a vise and cut the webbing off.

2. Connect deployment tool adapter [SST: KV99108200 (J38381-50)] to deployment tool [SST: KV99106400 (J38381)] connector and front seat

belt pre-tensioner connector.

3. Connect red clip of deployment tool to battery positive terminal and black clip to negative terminal.
4. The lamp on the right side of the tool, marked "deployment tool power", should glow green, not red.
5. Press the button on the deployment tool. The left side lamp on the tool, marked "seat belt pre-tensioner connector voltage", will illuminate and the

seat belt pre-tensioner will deploy.

CAUTION:  When deploying the front seat belt pre-tensioner, stand at least 5 m (16 ft) away from the seat belt pre-tensioner.

Deployment of Air Bag Module/Seat Belt Pre-Tensioner In Vehicle

-

Before disposing of air bag module and seat belt pre-tensioner, or vehicles equipped with such systems, deploy the systems. If such systems have
already been deployed due to an accident, dispose of them as indicated in "DISPOSING OF AIR BAG MODULE AND SEAT BELT
PRE-TENSIONER"

-

When deploying the air bag module and seat belt pre-tensioner, always use the Special Service Tool: Deployment tool [KV99106400 (J38381)].

-

When deploying the air bag module and seat belt pre-tensioner, stand at least 5 m (16 ft) away from the deployment component.

-

When deploying air bag module and seat belt pre-tensioner, a fairly loud noise is made, followed by smoke being released. The smoke is not
poisonous, however, be careful not to inhale smoke since it irritates the throat and can cause choking.

-

Always activate one air bag module at a time.

Removal And Installation|Page 14001 > < Removal And Installation|Page 13999