Q45 V8-4.5L (VK45DE) (2002)
Use suitable covers to protect upholstery carpet paint etc. when performing this procedure.
Preliminary Steps:
1.
Write down all radio station presets.
2.
Remove any accessory (phone charger etc.) from the 12V Power Outlet(s).
WARNING:
^
Do NOT use a "Computer Memory Saver" (9-volt power source) that plugs into the 12V Power Outlet(s) to retain memory settings on the
computer and radio.
^
No voltage should be present in the system when performing this procedure.
3.
Disconnect both battery cables.
4.
Wait at least 3 minutes before proceeding with the following steps.
Remove "B" Pillar Lower Trim Panel
5.
Remove the B Pillar Front Vent Grill as follows:
A.
Use a Plastic Pry Tool (from essential tool set # J46534) to remove the Screw Cover (see Figure 1A).
B.
Remove the Screw from the Vent Grill (see Figure 1B).
C.
Carefully pull the Vent Grill out of the B Pillar Lower Trim Panel (see Figure 1C).
6.
Use a Plastic Pry Tool (from essential tool set # J-46534) to release the rear end of the Driver's Door Sill Plate (see Figure 2).
^
This will allow clearance for removing the Door Molding (next step).