Q45 V8-4.5L (VK45DE) (2002)
Impact Sensor: Service and Repair
Crash Zone Sensor
REMOVAL
CAUTION:
-
Before servicing SRS, turn the ignition switch off, disconnect the battery ground cable and wait at least 3 minutes.
1. Remove front grille.
2. Remove crush zone sensor connector.
3. Remove crush zone sensor fixing nuts.
CAUTION:
-
Replace crash zone sensor if it has been dropped or sustained an impact.
-
Do not attempt to disassemble crash zone sensor.
INSTALLATION
To install, reverse the removal procedure sequence.
CAUTION:
-
Check crash zone sensor for proper installation.
-
After the work is complete, perform self-diagnosis to check that no malfunction is detected. Refer to "SRS Operation Check".