Q45 V8-4.5L (VK45DE) (2002)
Impact Sensor: Service and Repair
Side Air Bag (Satellite) Sensor
REMOVAL
CAUTION:
-
Before servicing SRS, turn the ignition switch off, disconnect the battery ground cable and wait at least 3 minutes.
1. Remove seat belt pre-tensioned. Refer to "BODY SIDE TRIM".
2. Remove side air bag (satellite) sensor fixing nuts.
3. Remove the side air bag (satellite) sensor connector.
CAUTION:
-
Do not use old bolts, replace with new ones.
-
Check side air bag (satellite) sensor to ensure they are free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace
it with new one.
-
Do not attempt to disassemble side air bag (satellite) sensor.
-
Replace side air bag (satellite) sensor if it has been dropped or sustained an impact.
-
When the front side air bag or side curtain air bag deploys, always replace it with a new one.
INSTALLATION
To install, reverse the removal procedure sequence.
CAUTION:
-
Check side air bag (satellite) sensor for proper installation.
-
After replacement of side air bag (satellite) sensor, perform self-diagnosis to check that no malfunction is detected. Refer to "SRS Operation
Check".