infiniti Workshop Repair Guides

Infiniti Workshop Service and Repair Manuals

A/T - Shift Lever Difficult to Move|Page 11448 > < A/T - Shift Lever Difficult to Move|Page 11442
Page 1
background image

Shifter A/T: All Technical Service Bulletins
A/T - Shift Lever Difficult to Move

Classification: 
AT01-002

Reference:
ITB01-031 

Date:
May 23, 2001

2002 Q45 A/T SHIFT LEVER DIFFICULT TO MOVE

APPLIED VEHICLES: 
2002 Q45 (F50) with Automatic Transmission

APPLIED VIN: 
Vehicles built before JNKBF01A02M002212

APPLIED DATES: 
Vehicles built before March 5, 2001

SERVICE INFORMATION

If an Applied 2002 Q45 exhibits the following symptom:

^

The automatic transmission (A/T) shift selector lever is difficult to shift from REVERSE to DRIVE, or from PARK to REVERSE,

The heater duct located under the center console may be interfering with the shift interlock solenoid release lever and preventing the solenoid from
releasing the selector when the brake is depressed.

Should it occur, use the information in this bulletin to cut out and remove a portion of the shift lock release plate and correct the condition.

SERVICE PROCEDURE

1.

Confirm the incident.

2.

Remove the automatic transmission (A/T) finisher as follows:

A.

Carefully lift up on the FRONT end of the finisher until the two front and two middle clips are released (see Figure 1A).

B.

Carefully lift up on the REAR end of the finisher until the two rear clips are released (see Figure 1B).

NOTE: 

Do not lift up on the portions of the A/T finisher that run next to the cup holder as they can break.

A/T - Shift Lever Difficult to Move|Page 11448 > < A/T - Shift Lever Difficult to Move|Page 11442