Q45 V8-4.5L (VK45DE) (2002)
19.
Remove the Diagnostics (blue) card from slot A of CONSULT-II and install the ECM Reprogramming card (orange) into slot A (see Figure 18).
CAUTION:
Do not use slot B.
20.
Make sure the DLC-II cable is still firmly plugged into the vehicle harness (see CAUTION below). Turn the ignition switch "ON" (do not start the
engine). CONSULT-II will turn on automatically (see Figure 19).
NOTE:
ALL Reprogramming operations are done with the DLC-II cable ONLY.
21.
Confirm that all electrical loads (except for the ignition) such as headlights, defroster, A/C, Audio (radio), cellular telephone (if applicable) are
"OFF".
CAUTION:
Do not unplug CONSULT-II from the vehicle while Reprogramming ECM. Do not attempt ECM reprogramming with any vehicle electrical loads
"ON" except for the ignition. ECM damage can occur.