Q45 V8-4494cc 4.5L DOHC (VH45) (1992)
Axle Shaft: Service and Repair
1.
Raise and support vehicle, then remove rear wheels.
2.
Remove wheel bearing locknut.
3.
Remove side flange mounting bolts from final drive side fig 4--then separate shaft.
4.
On the wheel side remove shaft by tapping with soft hammer.
5.
Reverse procedure to install noting the following;
a. Insert shaft into wheel hub, lightly tighten wheel bearing locknut.
b. attach side flange, side flange bolts, then tighten to specifications.
c. Tighten wheel bearing locknut to specifications.