infiniti Workshop Repair Guides

Infiniti Workshop Service and Repair Manuals

Power Locks|System Diagnosis > < Diagram Information and Instructions|Page 10321
Page 1
background image

Power Locks: Description and Operation

POWER SUPPLY AND GROUND

Power is supplied at all times

^

through 10 A fuse [No. [28], located in the fuse block (J/B)]

^

to key switch terminal (3)

Power is supplied to Body Control Module (BCM) terminal (69) through key switch terminal (4) when key switch is in ON position (key is
inserted in the ignition key cylinder).
BCM is connected to LCU01, LCU02, LCU03 and LCU04 as DATA LINE A-1 or A-2.
When door switch is in OPEN position, ground is supplied

^

to BCM terminal (32) or (37)

^

through front LH or RH door switch terminal (1).

When door is unlocked, ground is supplied

^

to each door LCU terminal (5)

^

from terminal (2) of each door unlock sensor.

When the door is locked with the key, ground is supplied

^

to LCU01 or LCU02 terminal (7)

^

from terminal (3) of the key cylinder switch LH or

^

from terminal (1) of the key cylinder switch RH

^

through body grounds (M14) and (M47).

When the door is unlocked with the key, ground is supplied

^

to BCM terminal (31) or (27)

^

from terminal (1) of the key cylinder switch LH or

^

from terminal (3) of the key cylinder switch RH

^

through body grounds (M14) and (M47).

When lock/unlock signal is sent to BCM or LCU, BCM sends a lock/unlock signal to LCUs via DATA LINE A-1 or A-2. LCUs then supply
power and ground to each door lock actuator.

OPERATION

^

The lock & unlock switch (SW) on driver's door trim can lock and unlock all doors.

^

With the lock knob on front LH or RH door set to "LOCK", all doors are locked.

^

With the door key inserted in the key cylinder on front LH or RH door, turning it to "LOCK", will lock all doors; turning it to "UNLOCK"
once unlocks the corresponding door; turning it to "UNLOCK" again within 5 seconds after the first unlock operation unlocks all of the
other doors.

However, if the ignition key is in the ignition key cylinder and one or more of the front doors are open, setting the lock & unlock switch, lock knob, or
the door key to "LOCK" locks the doors once but then immediately unlocks them - (KEY REMINDER DOOR SYSTEM )

Power Locks|System Diagnosis > < Diagram Information and Instructions|Page 10321