Q45t V8-4130cc 4.1L DOHC MFI (VH41) (1997)
Figure 8
12.
Advance the carriage with the hand wheel until the outboard cutting bit reaches the inside edge of the rotor surface (see Figure 8). Then, advance
the carriage movement hand wheel an additional one-third turn.
13.
Turn the depth-of-cut knobs individually to set each cutting bit to the desired depth of cut. Each cut may be between 0.002" and 0.004" (0.05 mm
and 0.10 mm), but the final cut must be made at 0.001 " (0.025 mm).
Figure 9
14.
Tighten the cutter locking knobs (see Figure 9).