Q45t V8-4130cc 4.1L DOHC MFI (VH41) (1997)
/Page-548010.png)
23. Apply liquid gasket to front cover upper and install front cover upper in the numerical order shown in the figure, tighten to 6.3 - 8.3 Nm (55.6 -
73.8 inch lbs.).
NOTE: Before Installing cover, check that timing chain and sprocket mating marks are aligned correctly. Also, install chain guide bolt on front
cover upper.
24. Install camshaft position sensor.
NOTE: Notch on exhaust camshaft on left bank is off-centered so that camshaft position sensor can be installed properly.
25. Install crankshaft pulley.
26. Set No. 1 piston at TDC on its compression stroke. Align the timing mark (orange paint) on crankshaft pulley wit timing indicator on front cover.
27. Install oil pan.
28. Install rocker cover.
