infiniti Workshop Repair Guides

Infiniti Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 612 > < Diagram Information and Instructions|Page 610
Page 5
background image

ELECTRICAL LOAD

The incident may be electrical load sensitive. Perform diagnosis with all accessories (including A/C, rear window defogger, radio, fog lamps) turned on.

ENGINE COMPARTMENT

There are several reasons a vehicle or engine vibration could cause an electrical complaint. Some of the things to check for are:

A.  Connectors which are inaccessible for diagnosis probing.
B.  Connectors which may not fully be seated.
C.  Wiring harness which are not long enough and are being stressed during engine vibrations or rocking.
D.  Wires laying across brackets or moving components.
E.  Loose, dirty or corroded ground wires.
F.  Wires routed too close to hot components.

To inspect components under the hood, start by verifying the integrity of ground connections.First check that the system is properly grounded. Then
check for loose connection by gently shaking the wiring or components as previously explained. Using the wiring diagrams inspect the wiring for
continuity.

FREEZING

The customer may indicate the incident goes away after the car warms up (winter time). In such cases the cause could be related to water freezing
somewhere in the wiring/electrical system.
There are two methods to check for this. The first is to arrange for the owner to leave his car overnight. Make sure it will get cold enough to demonstrate
his complaint. Leave the car parked outside overnight. In the morning, do a quick and thorough diagnosis of those electrical components which could be
affected.
The second method is to put the suspect component into a freezer long enough for any water to freeze. Reinstall the part into the car and check for the
reoccurrence of the incident. If it occurs, repair or replace the component.

HEAT SENSITIVE

The owner's problem may occur during hot weather or after car has sat for a short time. In such cases you will want to check for a heat sensitive
condition.
To determine if an electrical component is heat sensitive, heat the component with a heat gun or equivalent.

Diagram Information and Instructions|Page 612 > < Diagram Information and Instructions|Page 610