Q45t V8-4130cc 4.1L DOHC MFI (VH41) (1997)
/Page-1854002.png)
Camber, caster and kingpin inclination are preset at factory and cannot be adjusted.
1. Set vehicle on turning radius gauge.
2. Mount the tools as follows.
Tool number:
KV991040SO ( - )
KV99104010 No. 1 to 5
KV99104020 No. 6
KV99104030 No. 7
KV99104040 No. 8
KV99104050 No. 9
a. Select adapter which corresponds with wheel or hub shape from four type Nos. 6 to 9, as shown .
b. Screw selected adapter in until it contacts plate No. 1, refer to the illustration.
c. Remove wheel nuts.
d. Install guide bolts No. 2 to where wheel nuts were removed and tighten them by hand.
e. Install plate and adapter assembly to guide bolts No. 2
f.
Install springs No. 4 onto guide bolts 2. Then tighten nuts No. 3 evenly until a little before springs No. 4 are completely compressed.
g. Install center plate No. 5
h. Mount wheel alignment gauge on attachment plate.
NOTE: Before checking front wheel alignment, be sure to make a preliminary inspection. Vehicle must also be in the unladen position, i.e. fuel,
radiator coolant and engine oil full, spare tire, jack, hand tools and mats in designated positions.
Camber, Caster and King Pin Inclination
