QX4 V6-3275cc 3.3L SOHC MFI (VG33E) (1998)
MAP/BARO Switch Solenoid Valve: Testing and Inspection
MAP/BARO SWITCH SOLENOID VALVE
With CONSULT
1. Start engine and warm it up to normal operating temperature.
2. Perform "MAP/BARO SW/V" in "ACTIVE TEST" mode with CONSULT.
3. Check the following.
-
Condition: At idle under no-load
-
CONSULT display
-
Time for voltage to change
4. If NG, check solenoid valve as shown below.
Without CONSULT
1. Remove MAP/BARO switch solenoid valve.