infiniti Workshop Repair Guides

Infiniti Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 6491 > < Diagram Information and Instructions|Page 6489
Page 6
background image

F.  Wires routed too close to hot components.

To inspect components under the hood, start by verifying the integrity of ground connections.First check that the system is properly grounded. Then
check for loose connection by gently shaking the wiring or components as previously explained. Using the wiring diagrams inspect the wiring for
continuity.

FREEZING

The customer may indicate the incident goes away after the car warms up (winter time). In such cases the cause could be related to water freezing
somewhere in the wiring/electrical system.
There are two methods to check for this. The first is to arrange for the owner to leave his car overnight. Make sure it will get cold enough to demonstrate
his complaint. Leave the car parked outside overnight. In the morning, do a quick and thorough diagnosis of those electrical components which could be
affected.
The second method is to put the suspect component into a freezer long enough for any water to freeze. Reinstall the part into the car and check for the
reoccurrence of the incident. If it occurs, repair or replace the component.

HEAT SENSITIVE

The owner's problem may occur during hot weather or after car has sat for a short time. In such cases you will want to check for a heat sensitive
condition.
To determine if an electrical component is heat sensitive, heat the component with a heat gun or equivalent.

Do not heat components above 6O°C (14O°F).If incident occurs while heating the unit, either replace or properly insulate the component.

UNDER SEATING AREAS

An unclamped or loose harness can cause wiring to be pinched by seat components (such as slide guides) during vehicle vibration. If the wiring runs
under seating areas inspect wire routing for possible damage or pinching.

VEHICLE VIBRATION

The problem may occur or become worse while driving on a rough road or when engine is vibrating (idle with A/C on). In such a case, you will want to
check for a vibration related condition. Refer to the illustration below.

Diagram Information and Instructions|Page 6491 > < Diagram Information and Instructions|Page 6489