QX4 2WD V6-3.5L (VQ35DE) (2003)
Cruise Control Servo Cable: Adjustments
Automatic Speed Control Device (ASCD)
ASCD Wire Adjustment
ASCD Wire Adjustment
CAUTION: Be careful not to twist ASCD wire when removing it.
Do not tense ASCD wire excessively during adjustment.
Adjust the tension of ASCD wire in the following manner.
1. Loosen lock nut and adjusting nut.
2. Make sure that accelerator wire is properly adjusted.
Refer to "ACCELERATOR CONTROL SYSTEM" @ Fuel Delivery and Air Induction / Accelerator Pedal.
See: Powertrain Management/Fuel Delivery and Air Induction/Accelerator Pedal
3. Tighten adjusting nut just until throttle drum starts to move.
4. Loosen adjusting nut again 1/2 to 1 turn.
5. Tighten lock nut.