QX4 2WD V6-3.5L (VQ35DE) (2003)
5. Remove lock washer.
6. Remove wheel bearing lock nut.
7. Remove wheel hub and wheel bearing.
Be careful not to drop outer bearing.
INSTALLATION
1. After installing wheel hub and wheel bearing, adjust wheel bearing preload. Refer to "Preload Adjustment", "FRONT WHEEL BEARING",
"On-vehicle Service".
2. Pack drive flange groove with grease, apply grease to O-ring (two places) and mating surface of drive flange, and install flange. - 4WD -
3. Install snap ring. - 4WD