Power Trunk / Liftgate Lock Switch - Component Information - Diagrams - Page 14673
-
Some connectors do not have a notch above each terminal. To probe each terminal, remove the connector retainer to make contact space for
probing.
MALE TERMINAL
Carefully probe the contact surface of each terminal using a "T" pin.
Do not bend terminal.
How to Check Enlarged Contact Spring of Terminal
An enlarged contact spring of a terminal may create intermittent signals in the circuit.
If the intermittent open circuit occurs, follow the procedure below to tact spring of female terminal.
1. Assemble a male terminal and approx. 10 cm (3.9 in) of wire.
Use a male terminal which matches the female terminal.
2. Disconnect the suspected faulty connector and hold it terminal side up.