QX56 V8-5.6L (VK56DE) (2004)
/Page-2439007.png)
12.
Apply Adhesion Promoter to the Rear Spoiler (in the same area that you removed the Adhesive Tape).
^
The Adhesion Promoter will prepare the surface for the new Adhesive Tape. Allow the Adhesion Promoter to dry.
13.
Apply the Adhesive Tape (also contained in the Kit) onto the Rear Spoiler. See Figure 10.
^
Make sure the Tape is placed 3mm from the front edge of the Spoiler (see Figure 10).
^
Do NOT remove the adhesive tape backing yet. You'll be doing that in step 17.
14.
Install seven new Plastic Clips (also contained in the Kit) to the under-side of the Rear Spoiler (see Figure 10).
15.
Cut the Rear Glass Washer Fluid Hose and add a 45 degree Elbow (also contained in the Kit) as follows:
NOTE:
