QX56 V8-5.6L (VK56DE) (2004)
/Page-2439009.png)
17.
Remove the Adhesive Tape Backing by pulling on the extra (exposed) length (see Figure 12).
NOTE:
Lift UP on the front edge of the Spoiler while pulling the Adhesive Tape Backing. This will help prevent the Backing material from breaking
off.
18.
Re-install and tighten the two nuts that secure the Rear Spoiler.
^
Nut Torque: 3.5 N-m (0.36 kg-m, 31 in-lb).
19.
Use a Non-Marring Hard Rubber Roller to completely seat the Adhesive Tape (see Figure 13).
CAUTION:
Do NOT damage the Rear Spoiler when using the Roller.
^
Use the Roller to apply enough force until all air is purged out of the Tape (cannot hear any popping air bubbles).
20.
Re-install the rear Hatch Upper Finisher making sure:
