QX56 V8-5.6L (VK56DE) (2004)
/Page-652009.png)
^
Install key of crankshaft.
^
Lightly tapping its center with plastic hammer, insert pulley.
CAUTION: Do not tap pulley on the side surface where belt is installed (outer circumference).
13. Tighten crankshaft pulley bolt.
^
Lock crankshaft with a hammer handle or similar tool to tighten bolt.
^
Perform the following steps for angular tightening:
a. Apply engine oil onto threaded parts of bolt and seating. area.
b. Select one most visible notch of the four on bolt flange. Corresponding to the selected notch, put a mating mark (such as paint) on
crankshaft pulley.
Crankshaft pulley bolt torque
Step 1 : 93.1 Nm (9.5 kg-m, 69 ft. lbs.)
Step 2 : additional 90° (angle tightening)
14. Rotate crankshaft pulley in normal direction (clockwise when viewed from engine front) to check for parts interference.
15. Installation of the remaining components is in the reverse order of removal.
