QX56 V8-5.6L (VK56DE) (2004)
Power Distribution Module: Scan Tool Testing and Procedures
CONSULT-II Function
-
CONSULT-II can display each diagnostic item using the following diagnostic test modes: self-diagnostic results, data monitor, active test, and
CAN diagnostic support monitor through data reception and command transmission via the IPDM E/R communication line.
CONSULT-II BASIC OPERATION
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending
on control unit which carry out CAN communication.
1. With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn ignition switch ON.
2. Touch "START (NISSAN BASED VHCL)".
3. Touch "IPDM E/R" on "SELECT SYSTEM" screen.
-
If "IPDM E/R" is not displayed, print "SELECT SYSTEM" screen, go to "CONSULT-II Data Link Connector (DLC) Circuit". See:
Diagrams/Diagnostic Aids