QX56 AWD V8-5.6L (VK56DE) (2005)
/Page-2511004.png)
Figure 3
12. Remove the top screw only from the RH & LH side finishers (see Figure 4).
13. Remove both screws and finisher from the front edge of the seat (see Figure 4).
Figure 4
14. Disconnect the seat sub-harness connector from the slide motor (see Figure 5).
15. Remove two bolts, one from each side of the seat frame - M8, 12 mm head (see "Remove this bolt first" in Figure 5).
16. Remove the six nuts (3 on each side) and two base plates shown in Figure 5.
-
Removing these nuts will release the gear boxes.
Figure 5
17. Slide both sides of the seat rail back to the rear position (towards the seat back) and remove the worm gears, drive cable, motor, and gear boxes,
all as one unit, from the seat adjuster assembly (see Figure 6).
CAUTION:Avoid bending the drive cable. Bending the cable will result in noise during seat operation.
