QX56 AWD V8-5.6L (VK56DE) (2005)
/Page-1623013.png)
4.
The "REPROGRAM START" window should appear (see Figure 18).
NOTE:
^
If you get an error message, refer to the ECU Reprogramming Software Operations Manual.
^
The Operations Manual is found in ASIST under: CONSULT Utilities > CONSULT-II info.
CAUTION DURING REPROGRAMMING:
^
Do not unplug CONSULT-II from the vehicle during reprogramming. Permanent ABS/VDC damage can occur.
^
Do not open any door or the trunk during reprogramming.
^
On some vehicles, the cooling fans may come on during reprogramming. This is a normal condition. Do not disconnect the cooling fans.
Forgetting to reconnect them may cause severe engine damage. A vehicle battery charger is needed* to maintain the battery voltage level during
reprogramming.
*
You should have hooked up a battery charger in Section 1.
5.
Press [START] See Figure 18.
^
After a few seconds the window shown in Figure 19 will appear.
^
The screen backlight in CONSULT-II will now turn OFF.
^
When the screen backlight goes OFF ABS/VDC reprogramming has started.