QX56 AWD V8-5.6L (VK56DE) (2005)
/Page-1731011.png)
2.
Check the CONSULT-II's Charger Input reading (see Figure 15).
NOTE:
^
"Battery Voltage" is the voltage level of CONSULT-II's battery.
^
"Charger Input" is the voltage level of the vehicles battery. (It MUST be above 12 volts.)
3.
As mentioned, the Charger Input" reading MUST be above 12 volts (see Figure 15).
^
A reading above 12 volts confirms;
a.
The DLC-II is properly connected to the vehicle,
b.
The vehicle battery voltage is sufficient for ABS/VDC reprogramming, and
c.
CONSULT-II has a sufficient power supply to perform ABS/VDC reprogramming.
^
If the vehicle's battery voltage ("Charger Input") is below 12 volts, one or more of the following may be the cause:
a.
The battery charger you hooked up in section 1 is not charging the battery (poor connection or it is not working).
b.
The DLC-II does not have a good connection to the vehicle (not straight).
c.
The DLC-II cable may have a malfunction (damaged wire or pins).
d.
The CONSULT-II Converter (J44200-50 / black box) is not working correctly (see Figure 11).
CAUTION:
^
Do not attempt ABS/VDC reprogramming if the vehicle's battery voltage is below 12 volts.
^
Permanent ABS/VDC damage can occur if the vehicle battery does not maintain the minimum voltage during ABS/VDC reprogramming.
^
If "Charger Input" is above 12 volts, power from the vehicle battery will keep CONSULT-II's power supply at the correct level during
reprogramming (see Figure 15).
4.
Continue with Section 4.
Section 4
Section 4: Perform ABS/VDC Control Unit Reprogramming
1.
Press [BACK] two times.
