QX56 AWD V8-5.6L (VK56DE) (2005)
ICC Sensor: Adjustments
LASER BEAM AIMING ADJUSTMENT
Outline of Laser Beam Aiming Adjustment Procedure
CAUTION:
-
The laser beam aiming adjustment cannot be performed without CONSULT-II.
-
The laser beam aiming adjustment must be performed every time the ICC sensor is removed, installed or has been moved as a result of a collision.
1. Prepare the vehicle and the work area.
2. Set up the ICC target board.
Tool number : KV99110100 (J-45718)
3. Adjust the sensor following the procedure on CONSULT-II.
4. Check system operation after the adjustment.
Preparation
-
Place the vehicle on level ground. Shift the transmission into "P" position and release the parking brake.
-
Adjust the tire pressure to the specified value.
-
See that there is no load in the vehicle. Coolant, engine oil and fuel should be filled to correct level.
-
Check that the vehicle suspension has been adjusted to the standard height by the load leveling rear air suspension system. Refer to "Basic
Inspection".
-
Clean the sensor with a soft cloth.
Setting up the ICC Target Board
CAUTION: Accuracy in setting up the ICC target board is essential for the laser beam aiming adjustment.
ADJUSTING HEIGHT OF THE TARGET
1. Attach a triangle scale as shown.