QX56 AWD V8-5.6L (VK56DE) (2005)
/Page-2661005.png)
d. Connect the white 3-wire connector into the top of the Fuel Pump (see Figure 5).
e. Push and pull all connectors to make sure they are fully locked in place.
f. Use the new tie-wrap to secure all the wires to the black corrugated tubing. These include the three Fuel Level Sending Unit wires and the two Fuel
Pump wires (see Figure 5).
^
A new tire-wrap is included with the Sending Unit.
^
Place the tie-wrap 90 mm (about 3.5 inches) from the top of the tubing.
^
Cut off excess tie wrap.
^
Make sure the wires do not interfere with the movement of the float arm.
5. Carefully reinstall the Fuel Pump Assembly into the Fuel Tank.
^ Refer to the Service Manual as needed.
CAUTION:
Do NOT bend the Float Arm when re-installing the Fuel Pump.
6. Reinstall the Fuel Tank into the vehicle.
^ Refer to the Service Manual as needed.
7. Confirm the Fuel Gauge operates properly.
