QX56 AWD V8-5.6L (VK56DE) (2005)
CAUTION: Do not overtighten bolts, otherwise, they may be damaged.
How to Follow/Perform Trouble Diagnosis
How to Follow Trouble Diagnosis
NOTE: Trouble diagnosis indicates work procedures required to diagnose problems effectively. Observe the following instructions before diagnosing.
1. Before performing trouble diagnosis, read the "Preliminary Check", the "Symptom Matrix Chart" or the "Work Flow".
2. After repairs, re-check that the problem has been completely eliminated.
3. Refer to Component Parts and Harness Connector Location for the Systems described for identification/location of components and harness
connectors.
4. Refer to the Circuit Diagram for quick pinpoint check.
If you need to check circuit continuity between harness connectors in more detail, such as when a sub-harness is used, refer to Wiring Diagram in
each individual section and Harness Layout for identification of harness connectors.
5. When checking circuit continuity, ignition switch should be OFF.
6. Before checking voltage at connectors, check battery voltage.
7. After accomplishing the Diagnostic Procedures and Electrical Components Inspection, make sure that all harness connectors are reconnected as
they were.
DESCRIPTION
NOTE: Trouble diagnosis indicate work procedures required to diagnose problems effectively. Observe the following instructions before diagnosing.
1. Before performing trouble diagnosis, read the "Preliminary Check", the "Symptom Matrix Chart" or the "Work Flow".
2. After repairs, re-check that the problem has been completely eliminated.
3. Refer to Component Parts and Harness Connector Location for the Systems described for identification/location of components and harness
connectors.
4. Refer to the Circuit Diagram for quick pinpoint check.
If you need to check circuit continuity between harness connectors in more detail, such as when a sub-harness is used, refer to Wiring Diagram in
each individual section and Harness Layout in Power Supply, Ground & Circuit Elements for identification of harness connectors.
5. When checking circuit continuity, ignition switch should be OFF.
6. Before checking voltage at connectors, check battery voltage.
7. After accomplishing the Diagnostic Procedures and Electrical Components Inspection, make sure that all harness connectors are reconnected as
they were.