QX56 AWD V8-5.6L (VK56DE) (2005)
e. Unplug the White Wire Connector at the top ofthe fuel pump.
^
DO NOT disturb the Black Wire Connector located next to the white Wire connector.
f. Carefully cut the tie-wrap securing the harnesses to the corrugated tubing.
CAUTION:
DO NOT damage the wires or the wire insulation when cutting the Tie-Wrap.
3. Install the new Fuel Gauge Sender Unit as follows (see Figure 5):
CAUTION:
Do not bend the float arm when handling the new Fuel Gauge Sender Unit / Fuel Pump Assembly.
a. Slide the new Fuel Gauge Sender Unit into the attachment slots until the two Locking Tabs snap in place.