QX56 AWD V8-5.6L (VK56DE) (2005)
^
If you have done steps 2 through 7 twice and DTC C1179 is not detected this bulletin does not apply. Go to ASIST for further diagnostic
information.
Part 2
Part 2:
Download special ABS/VDC Reprogramming Data from ASIST onto your standard 8 MB (orange) Reprogramming Card.
This part of the procedure involves two general steps:
^
Setting up
^
Download (transfer) data from ASIST into CONSULT-II (8 MB orange Reprogramming card).
SETTING UP:
1.
Install the standard 8 MB (orange) Reprogramming Card into CONSULT-II.
Use slot A-top slot (see Figure 1).
2.
Connect the AC power supply to CONSULT-II.
3.
Connect CONSULT-II to the ASIST PC with the special Ethernet cable (P/N 02002554 is printed on the cable).
a.
Connect one end to CONSULT-II at the "PC port".
b.
Connect the other end to the ASIST PC at the Ethernet Card connection port.
4.
Confirm the CONSULT-II date and time are correctly set as follows:
(This is necessary to provide a valid print-out for warranty claims.)
a.
With the 8MB (orange) Reprogramming card in slot A turn ON CONSULT-II.
b.
Touch [SUB MODE]