QX56 AWD V8-5.6L (VK56DE) (2005)
^
If cables are very often changed at the DDL Port (base) of the CONSULT-II unit cable connector pin damage may result.
^
If there is connector pin damage ABS/VDC reprogramming may fail. Permanent damage to the ABS/VDC system can occur.
4.
Continue with Section 2.
Section 2
Section 2: Check all Systems in "SELF-DIAG RESULTS" and erase any DTC(s).
CAUTION:
It is essential that you check all Systems in "SELF-DIAG RESULTS" and erase any DTC(s) before performing the remaining sections of this
procedure.
1.
Remove the 8 MB orange card from CONSULT-II.
2.
Install the 16 MB (red/white) Diagnostic Card into Slot A (top slot) of CONSULT-II (see Figure 12).
3.
Press [START (Nissan BASED VHCL)].
4.
In "SELF-DIAG RESULTS" check and erase any DTC(s) that are stored in the following vehicle Systems:
^
ENGINE
^
A/T
^
ABS
^
AIR BAG
^
ALL MODE AWD/4WD (if applicable)
^
DIFF LOCK (if applicable; 4WD Titan)
^
AIR LEVELIZER (if applicable)
5.
Turn the ignition switch to the OFF position and then turn CONSULT-II OFF.
6.
Remove the red/white Diagnostic Card and insert the 8 MB orange Reprogramming Card into CONSULT-II. The 8 MB reprogramming card
should already have special ABS/VDC reprogramming data loaded into it (see Part 1).
7.
Turn the ignition switch ON (do not start the engine).