QX56 AWD V8-5.6L (VK56DE) (2005)
b.
Disconnect both battery cables (negative cable first).
c.
Wait at least 3 minutes after the battery cables are disconnected.
2.
Place the seat on a clean working surface.
3.
Take the buckle pre-tensioner harness loose from its mounting points under the seat.
^
Remove clips vinyl tape and canvas cover as needed.
^
Refer to Figure 11 for the driver seat and Figure 13 for the passenger side.
NOTE:
You'll be changing some of the mounting points during reassembly. New locations are shown in reassembly steps.
4.
Remove the seat belt buckle pre-tensioner as follows: