QX56 AWD V8-5.6L (VK56DE) (2005)
/Page-2259010.png)
D.
Position the Solder Sleeve Connector so that the solder ring (in the connector) is centered around the exposed twisted wire area (see Figure
D).
E.
Use the special Flameless Heat Gun-J-46538 to heat the Solder Connector.
This operation will:
^
Melt the solder (silver ring inside the Solder Sleeve Connector) into the exposed twisted wire area.
^
Melt the sealant (red rings inside solder connector) onto the wires.
^
Shrink the plastic sleeve onto the wires
Important Soldering Tips:
^
Position the Solder Connector in the middle of the heat shield (of the Heat Gun).
^
Start heating the connector from the center and move back and forth (side to side) and around to allow even distribution of the heat to the
entire connector.
^
Make sure the solder completely flows into the exposed twisted wires and the adhesive properly seals the wire insulation to the connector
sleeve. Stop applying the heat immediately after this happens.
WARNING:
^
The Flame-Less Heat Gun and the Solder Connectors become HOT during the soldering process.
^
Allow the Gun and connectors to cool down before handling them.
CAUTION:
Be careful not to damage the connector or wires with the heat gun:
