QX56 AWD V8-5.6L (VK56DE) (2005)
^
Make sure the connectors are securely connected ("snapped" in place).
10.
Secure the new BCM Sub-Harness to the Existing Vehicle Harness (see Figure 8).
^
Use the Tie Wrap that comes already attached to the new Sub-Harness.
11.
Re-connect the negative battery cable.
12.
Confirm the installed BCM Sub-Harness does not interfere with the operation of the adjustable pedal assembly.
NOTE:
It is okay if the BCM Sub-Harness has slight contact with the adjustable pedal assembly when the pedal assembly is adjusted to the end of its
upward travel (closest to the driver).
13.
Re-install all components in reverse order of removal.
14.
Re-program all radio station presets.
15.
If the BCM was replaced, you'll need to do the following:
IMPORTANT:
You MUST perform the following steps according to the applicable service manual to ensure the new BCM is properly programmed to the
original vehicle settings.
^
BCM "Write Configuration" using CONSULT-II. Refer to "WRITE CONFIGURATION PROCEDURE" in section BCS of the applicable
service manual.
^
Initialization of NATS System and Registration of all NATS Ignition Key I.D.s. Refer to Infiniti Technical Bulletin ITB04-018a.
^
I.D. Registration Procedure of the Low Tire Pressure Warning System. Refer to I.D. REGISTRATION PROCEDURE" in section "WT" of
the applicable service manual.
^
Register I.D. Code for Remote Keyless Entry Key fobs. Refer to section "BL" of the applicable service manual.
^
BCM Headlamp Configuration. Refer to "HEADLAMP" information in section "LT" of the applicable service manual.