QX56 AWD V8-5.6L (VK56DE) (2005)
Drive/Propeller Shaft: Service and Repair
Rear
Removal and Installation
Removal and Installation
Model 2S1350
REMOVAL
1. Move the A/T select lever to the N position and release the parking brake.
2. Put matching marks on the rear propeller shaft flange yoke and the companion flange of the rear final drive as shown.
CAUTION: For matching marks, use paint. Never damage the rear propeller shaft flange yoke or the companion flange.
3. Remove the bolts, then remove the propeller shaft from the rear final drive and A/T.
INSTALLATION
Installation is in the reverse order of removal.
^
After installation, check for vibration by driving the vehicle.
CAUTION: Do not reuse the bolts and nuts. Always install new ones.
Inspection After Removal