Amigo 2WD V6-32L (1999) Radiator Component Diagrams | Page 1528
Important operation (in case of 100% engine coolant change) procedure for filling with engine coolant.
-
Remove radiator cap.
-
Fill with engine coolant (EC) to the radiator filler neck.
-
Fill with EC to the "MAX" line on the reservoir.
-
Start the engine with the radiator cap removed and bring to operating temperature by running engine at 2,500 - 3,000 rpm for 30 minutes.
-
By EC temperature gauge reading make sure that the thermostat is open.
-
If air bubbles come up to the radiator filler neck, replenish with EC repeat until the EC level does not drop any further. Install the radiator cap
and stop the engine.
-
Replenish EC to the "MAX" line on the reservoir and leave as it is until the engine gets cool.
-
After the engine gets cool, start the engine and make sure there is no water running noise heard from the heater core while the engine runs at
3,000 rpm.
-
Should water running noise be heard, repeat the same procedure from the beginning.