Amigo 2WD V6-3.2L (1999)
Apply sealant (TB-1207B or equivalent) of bead diameter 2-3 mm at eight place of arched area of camshaft bracket on front and rear sides.
-
The cylinder head cover must be installed within 5 minutes after sealant application to prevent premature hardening of sealant.
-
Tighten bolts to the specified torque.
Torque: 9 Nm (80 inch lbs.)
2. Install exhaust gas recirculation pipe and tighten to specified torque.
Torque:
Exhaust manifold side: 28 Nm (21 ft. lbs.)
Flare nut: 44 Nm (33 ft. lbs.)
Cylinder head side: 25 Nm (18 ft. lbs.)
3. Tighten fuel injector harness bracket bolts to specified torque then reconnect fuel injector harness connector.
Torque: 7.8 Nm (5.7 ft. lbs.)
4. Install heater pipe bolt to the specified torque.
Torque: 21 Nm (15 ft. lbs.)
5. Connect ignition coil connector and tighten ignition coil fixing bolts to specified torque.
Torque: 4 Nm (35 inch lbs.)
6. Connect ventilation hose to cylinder head.
