Amigo 2WD V6-3.2L (1999)
Steps 10 - 11
Fuel Injector Coil Test Procedure and Fuel Injector Balance Test Procedure
Test Description
Number(s) below refer to the step number(s) on the Diagnostic Chart:
2. Relieve the fuel pressure by connecting the J 34730-1 Fuel Pressure Gauge to the fuel pressure connection on the fuel rail.
CAUTION: In order to reduce the risk of fire and personal injury, wrap a shop towel around the fuel pressure connection. The towel will absorb
any fuel leakage that occurs during the connection of the fuel pressure gauge. Place the towel in an approved container when the connection of the
fuel pressure gauge is complete.
Place the fuel pressure gauge bleed hose in an approved gasoline container. With the ignition switch OFF, open the valve on the fuel pressure
gauge.
3. Record the lowest voltage displayed by the DVM after the first second of the test. (During the first second, voltage displayed by the DVM may be
inaccurate due to the initial current surge.)
-
The voltage displayed by the DVM should be within the specified range.
-
The voltage displayed by the DVM may increase throughout the test as the fuel injector windings warm and the resistance of the fuel injector
windings changes.
-
An erratic voltage reading (large fluctuations in voltage that do not stabilize) indicates an intermittent connection within the fuel injector.
