Amigo 2WD V6-3.2L (1999)
Wiper Blade: Service and Repair
Windshield Wiper Arm/Blade
Removal
1. Dry the cap (2) off with the tip of a screwdriver.
2. Remove the nut.
3. Remove the wiper arm/blade (1).
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Wiper arm/blade
-
Before installing the wiper arm/blade to the shaft, confirm that the motor stops at the auto stop position.
-
Set the wiper arm/blade so that the tips of both blades are positioned about 40 mm (1.57 in) from the upper edge of the cowl cover as shown in
the figure.
-
Tighten the nuts to the specified torque.
Torque: 23 Nm (17 lb.ft)