Amigo 4WD L4-2559cc 2.6L SOHC (4ZE1) (1993)
Idle Speed: Adjustments
Idle Speed, Adjust
Pre-Adjustment Requirements
PURPOSE
To ensure correct results of procedures.
OPERATIONS
Prior to checking or adjusting engine operation the following procedures must be performed.
Inspect Fuel System
-
Fuel clamps are tight and fuel is not leaking.
-
Check fuel pipes and hoses for corrosion, damage, cracks, etc.
-
Fuel filter is not clogged, fuel lines not restricted or hoses colapsed.
-
Water is not present in fuel, filter or lines.
-
Unleaded fuel is used in fuel system.
Inspect Air Intake System
-
No leaks in the intake ducting.
-
No vacuum leaks at intake manifold gasket.
-
Exhaust Gas Recirculation (EGR) valve gasket is not leaking.
-
All vacuum lines are connected properly, not leaking.
-
Positive Crankcase Ventilation (PCV) hoses are connected and not leaking.
-
Oil filler cap is installed and not leaking.
-
Oil dipstick is installed and not leaking.
Inspect Electrical System
-
All electrical connections are secure.
-
All connections are correct.
-
Engine Control Module (ECM) harnesses are routed properly and are at least 100 mm (4 in) from ignition cables.
California
NOTE: Restrictions in the idle air port cause idle speed fluctuations. Check and clean as needed.
Before attempting to check and/or adjust idle speed, ensure that the following conditions are met:
-
Engine at operating temperature.
-
Throttle valve switch completely closed with idle contact on.
-
If equipped with power steering, front wheels straight ahead.
-
A/C "OFF" is so equipped.
-
Transmission in neutral.
-
Automatic transmission in either "N" or "P."
Canister Control Solenoid Connector
-
Pressure control VSV electrical harness disconnected.